Product Showcase
Uni-strut Stoneclip Metal Support System For External Panel Cladding
Product/Service Name
Uni-Strut StoneClip Metal Support System
ApplicationsBy using the Uni-Strut StoneClip 62mm x 41mm or 41mm x 41mm or 41mm x 21mm metal support system you can effect a cavity from 51mm to 165mm (x 2.5 mm wall thickness channel to be used) on any substrate that is being clad with any type of panel cladding, and in doing so you can eliminate the need to install Shelf Angles at each floor level, as the dead load is being supported by the individual StoneClips
Recent ProjectsUni-Strut StoneClip can be found throughout Australia and internationally, including India, Pakistan, Bangladesh, Sri Lanka, Nepal, United Arab Emirates, Oman, Qatar, Bahrain, Kuwait, and Saudi Arabia
Colours and FinishesLoad limits on the Uni-Strut StoneClip should be kept to 45kgs/12mm clip at 75mm unsupported cavity per clip, up to 55kgs/16mm clip at 90mm unsupported cavity. This gives you a maximum cavity of up to 150mm with the 12mm StoneClip up to a maximum of 175mm for the 16mm StoneClip. These widths are when using the 62mm deep channel.
SizesThe Uni-Strut StoneClip comes in 2 sizes (12mm and 16mm) and are 150mm long with their own channel nuts, base plates and 2 lock nuts. The cavities are all allowing for an unsupported length of thread of 75mm on the 12mm StoneClips and 90mm on the 16mm StoneClips
General Advantages• Working with an approved vertical support system.
• Allows fixing to solid parts of the substrate if slotted channel is used.
• Utilises the unique StoneClip mechanical fixing head.
• Works well with substrates that are not in PLUMB
• No epoxy needed to fix your cladding panels to substrate only needed to effect the width of the joint between the panel courses.
• Allows greater productivity with the system as when you have one panel fixed you are immediately ready to fix the one above.